Simulate with complex geometries and complex physics
SimCut
(chamberwise) parameter to stop filling of geometry by MESHFREE points after a certain number of filling cycles (UCV)
SimCut = 10
Default: SimCut = 0
If a positve number is given, MESHFREE will perform the given number of filling iterations
for interior points. Then it generates an output as defined by the SAVE parameters, after that MESHFREE stops.
Note: This parameter can also be set chamberwise for multiphase simulations (see also KindOfProblem, CHAMBER).
If it is not set for specific chambers, it is automatically set according to the non-chamberwise definition for all chambers.
Special feature:
SimCut = -10
With a negative number for SimCut, MESHFREE will perform abs(SimCut) filling cycles for interior points.
After this, the simulation is started regularly.
Note: This parameter can be overwritten by the CommandLine option --model-check. See ModelCheck.
| This item is referenced in: | |
|---|---|
| FAQ | overview of frequently asked questions and hints for solution |
| tut3d_00 | TUTORIAL 0: Checking the geometry |
| SimCut | (chamberwise) parameter to stop filling of geometry by MESHFREE points after a certain number of filling cycles (CV) |
| SimCut | (chamberwise) parameter to stop filling of geometry by MESHFREE points after a certain number of filling cycles (UCVO) |
| SimCut | (chamberwise) parameter to stop filling of geometry by MESHFREE points after a certain number of filling cycles (UCV) |
| %GEO_RemoveClusterByIndex% | %GEO_RemoveClusterByIndex% |
| Beta | Latest release notes for the MESHFREE beta executables |
| All | Complete release notes for the MESHFREE beta executables |
| ModelCheck | Check the model before a full simulation |