SimCutBoundary

(chamberwise) parameter to stop filling of boundary by MESHFREE points after a certain number of filling cycles (UCV)

Default: SimCutBoundary = 1000 If a positve number is given, then MESHFREE will perform the given number of filling iterations for boundary points. Note: This parameter can also be set chamberwise for multiphase simulations (see also KindOfProblem, CHAMBER). If it is not set for specific chambers, it is automatically set according to the non-chamberwise definition for all chambers.
This item is referenced in:
FAQ overview of frequently asked questions and hints for solution
SimCutBoundary (chamberwise) parameter to stop filling of boundary by MESHFREE points after a certain number of filling cycles (CV)
SimCutBoundary (chamberwise) parameter to stop filling of boundary by MESHFREE points after a certain number of filling cycles (UCVO)
SimCutBoundary (chamberwise) parameter to stop filling of boundary by MESHFREE points after a certain number of filling cycles (UCV)
Beta Latest release notes for the MESHFREE beta executables
All Complete release notes for the MESHFREE beta executables